Moldboard Plowing requires good moldboards to properly turn the soil. Signs of excessive wear include a very thin or razor sharp outer edge, "dished-out" wear above the share and behind the shin, or a dull look on the surface rather than a nice shiny polish. New moldboards are only offered on plow bottoms which are the 'throw-away' share type as listed below.
NEW MOLDBOARDS SHOULD BE REPLACED WITH NEW SHINS TO ENSURE PROPER WEARING SURFACE!
14" HS moldboard replaces OEM part: A20700, BA1022A, BA13290A, AA11746, HS314NC, HS314FC, HS354NC, HS354FC, HS444NC, HS444FC, HS544FC, HS544NC
16" HS molboard replaces OEM part: A200702, A13292A, AA11746, HS316FC, HS316NC, HS316, HS446NC, HS446FC, HS546NC, HS546FC
16" NU moldboard replaces OEM part: A15596, AA14885, NU1036, NU1046, NU1056, A20895
18" NU moldboard replaces OEM part: A17431, AA15673, NU1048FC, NU1048
HS moldboards
made in 14 & 16 inch sizes.
14" has 2 bolts along the bottom edge
16" has 3 bolts along the bottom edge
NU series moldboards
16" & 18" are available yet today
16" has 3 bolts along bottom edge
18" has 4 bolts along bottom edge
If you're not sure what plow bottom is on your plow see the "Identify your Plow Bottom" link on the right hand navigation bar.
14 inch moldboards have only 2 bolts along the bottom edge
16 inch moldboards have 3 bolts along the bottom edge.
18 inch moldboards have 4 bolts along the bottom edge.
Contact us today!
We welcome your questions and queries. Please see our Contact Us page for complete contact information.
Copyright 2020 The Plow Guy. All rights reserved.
This website is in no way affiliated with Deere & Company.