The 520 LP which we all had a part in restoring!

Plowing with 2-14" JD 412 plow! FUN!!

Taking extra care for detail installing decals

I had to seek technical assistance on the fine details from Mom!

Alex driving the 520 in the 2005 East Perry County Fair parade.

Dad and Mom posing with the 520 after the 2005 River Hills Antique Tractor Club Heritage Ride!

The 520 before the sheet metal was finished

Got her up on blocks just like in the ghetto....so just installing new tires & painting the rims/ hubs.

My custom paint hoist

No .020 undersize rod bearings were available so I had Effingham Regrinders pour Babbit and it's great!

New Pistons....I don't think so....made due with the old ones...new rings and ring gap spacers and is like new.

CLICK HERE TO SEE THE LISTING OF WHAT WE DID TO THIS TRACTOR!

Here is a list of new parts: Tires (all 4 , Front Rims, Rear rims were donors from a 60, Paint, Decals, Piston Rings, Wrist Pins, Cylinder Block (bored, sleeved back to std., bored again), Cylinder Head (cracks pined, valves, seats, springs, keepers, machined tapped passage on #2 and pressed in steel sleeve...and of course drilled out broken studs ;) , BEARINGS (all new except for differential)!!!, BUSHINGS-(all new except for differential)!!!, SEALS- (all new except for differential)!!!, GASKETS- (all new except for differential)!!!, Battery Box, Float ride seat (completely rebuilt with USA MADE PARTS!!!!), Remote Valve lines (the originals were cut off), PTO (CLUTCHES, BUSHINGS IN THE BOTTOM OF THE TRANS CASE), BRAKES, POWER STEERING SYSTEM, RADIATOR CORE, WATER PUMP, GOVERNOR, HYDRAULIC PUMP, LP GAS SYSTEM (INCLUDING CONVERTOR, LINES, STRAINER, HOSES, ECT.), GENERATOR, STARTER MOTOR, LIGHTS, DASH PANEL, SPEED/HOUR MEETER, GAUGES, SWITCH, STEERING WHEEL, EXHAUST PIPE & MUFFLER, CLUTCH (DISCS & FACINGS, DRIV